Solutions

How-To Articles

How to disable NAT for Web traffic using custom rule

09-03-2020 15:38:14 0 0

Overview

This article describes how to disable NAT for web traffic

In a certain scenario, we do not want traffic being NATed while accessing intranet/local web services in an internal network, at this time you can use disable NAT feature to avoid traffic being NATed

Note: This rule only applies in gateway mode connected devices

Applicable Version: 2.4 and Above

Configuration:

Please configure a custom rule for LAN-WAN traffic

Navigate to Firewall > Custom Rules.

Select + Add Firewall Rule.

Select the Source Zone to LAN.

Definition Type: Network Definition

ADD IP or Network into Source which you want to bypass from a proxy.

ADD Services to HTTP (port 80) and HTTPS (port 443).

Select the Source Zone to WAN

Definition Type: Network Definition

ADD Destination Zone: ANY

Uncheck Apply NAT option

Select Bypass UTM policies option

Apply to save the rule

Please contact Seqrite Technical Support for more assistance

Vote

Was this article helpful?
0 out of 0 found this helpful