Due to additional security measures, we have implemented Multi-Factor Authentication (MFA) on this Support Portal. Please log in using your registered email ID or phone number. In case of any difficulty, kindly reach out to Seqrite Support by emailing us at "support@seqrite.com".

How-To Articles

How to disable NAT for Web traffic using custom rule

09-03-2020 15:38:14


This article describes how to disable NAT for web traffic

In a certain scenario, we do not want traffic being NATed while accessing intranet/local web services in an internal network, at this time you can use disable NAT feature to avoid traffic being NATed

Note: This rule only applies in gateway mode connected devices

Applicable Version: 2.4 and Above


Please configure a custom rule for LAN-WAN traffic

Navigate to Firewall > Custom Rules.

Select + Add Firewall Rule.

Select the Source Zone to LAN.

Definition Type: Network Definition

ADD IP or Network into Source which you want to bypass from a proxy.

ADD Services to HTTP (port 80) and HTTPS (port 443).

Select the Source Zone to WAN

Definition Type: Network Definition

ADD Destination Zone: ANY

Uncheck Apply NAT option

Select Bypass UTM policies option

Apply to save the rule

Please contact Seqrite Technical Support for more assistance